All Prices in Cnd funds  Canadian Funds To US Prices  US Funds
 
STANDARD SHOTGUN SHELL
DRAWER / CABINET DOOR KNOBS
$6.50 ea
Standard Shotgun Shell Drawer Knobs
Standard Shotgun Shell Drawer / Cabinet Door Knobs are handmade using the nickel heads (the ends) of authentic Winchester 12 gauge shotgun shells and the stem is made using authentic nickel cartridge cases.

Made entirely of nickel components, they will stay shiny.  There is no live primers and the colour of the used primers will vary (brass, nickel or copper).  Refer to picture of this cabinet door knob installed.

These are designed to install on 9/16" thick cupboard door/drawer.

8-32 bolt (supplied) requires approx. a 11\64" to 3/16" hole to accommodate the bolt.  If you have a thicker/thinner application, you will have to go to your local hardware for your required length bolt.

* Knob height is approx. 1"
* Knob diameter is 7/8" (across the head)
* Mounting hardware included
Drawer and Cabinet Door Knobs are made using the nickel ends of fired shotgun shell hulls; there may be some dings and other imperfections on the head, and the headstamp (the lettering) depth may not be consistent.
INSTALLATION INSTRUCTIONS

When tightening, you will have 1/4" of play (travel) in the bolt.  DO NOT over tighten or you will strip the threads or push the primer out.

When installing, hold the stem of the knob to prevent turning and tighten the bolt gently, until finger snug.

Some variance can be taken up with the washer (supplied).

Shipping and Handling Information
Destination Service S&H Fee Insurance Tracking Transit Time
Canada Expedited Parcel $9.00 - $16.00 * included included 1 - 2 weeks
USA Small Packet Air $ 9.00   included n/a 2 weeks
Due to the restrictive Canada Post minimum width (slot size) these have to go by parcel rate.
i.e. if you order one, the S&H will start at $9.
* remote locations will be higher
For complete information, please refer to our Shipping policies.

  Return   Order Page   Site Map